Version 1.2 Page 10 4/22/04
BMC System Console
On the RX2600, the Baseboard Management Console (BMC) is accessible through the serial port on the
back of the system labeled Console/Serial A. This port is set to 9600 baud 8 bit no parity and one stop bit.
Entering Console Mode
To get the console processors attention and enter command mode, enter <ESC>(. You receive the cli>
prompt, at which point you can enter commands.
Exiting Console Mode
To exit the console processor command mode, enter <ESC>Q. If OpenVMS is running, you are returned
to the operating system prompt.
Command Summary
Command Description
C [<passwordstring>] Change Password
CON Display console selection
FPL Read forward progress log
H Help
I <ipmi command data> Send any IPMI message
req fmt: rsSA netfnlun chk1 rqSWID rqSeq cmd [data] chk2
resp fmt: rqSWID netfnlun chk3 rsSa rqSeqrsLun cmd ccode [data] chk4
INFO Display BMC FW revision
IPMI <ipmi command data> Send any IPMI message
req fmt: netfnlun cmd [data]
resp fmt: ccode [data]
LOC [0,1] Locator LED control
P [0,1] Power control
Q Quit/Logout
RS [s] Reset system [and switch to sys console]
SD Read SDR repository
SE Read System Event Log
TOC [s] Send an INIT/TOC [and switch to sys console]
