5: Commands and Levels
<number> = maximum number of HTTP server log entries.
Sets the maximum time the HTTP server waits when receiving a
request.
<seconds> = maximum timeout value.
Restores the HTTP counters to the aggregate values.
Disables the HTTP Server port.
Clears the RSA/DSA certificate selection.
Disables the HTTP Server SSL port.
Sets the port number the HTTP server will use.
<number> = port number.
secure credentials <text>
Selects the RSA/DSA certificates by name for the HTTP server.
Sets the port number the HTTP server will use over SSL.
<number> = port number.
secure protocols ssl3 disable
secure protocols ssl3 enable
secure protocols tls1.0 disable
secure protocols tls1.0 enable
secure protocols tls1.1 disable
secure protocols tls1.1 enable
Displays the current configuration.
Displays the HTTP server authentication settings.
Displays the last 20 commands entered during the current CLI
session.
Displays the HTTP server log.
Displays the HTTP statistics.
Disables the HTTP server.
Stores the current configuration in permanent memory.
icmp (config-icmp) level commands
Exits to the configuration level.
Displays the current configuration.
Displays the last 20 commands entered during the current CLI
session.
Prevents ICMP packets from being sent or received.
Allows ICMP packets to be sent and received.
Stores the current configuration in permanent memory.
if 1 (config-if:eth0) level commands
default gateway <IP address>
Sets the configurable gateway IP address to the default value.
Restores the default Maximum Transmission Unit (MTU) size.
PremierWave EN Command Reference 178
