A SERVICE OF

logo

Open as PDF
next previous
5: Commands and Levels
above it,
to adjust the order of the defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling connections estab-
lished by the
device in milliseconds.
<milliseconds> = timeout in milliseconds.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays tunnel connect status.
start character <control>
Sets the connect mode start character.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
write
Stores the current configuration in permanent memory.
connect (tunnel-connect:2) level commands
block network disable
Forwards (tunnels) network data in connect mode tunneling.
block network enable
Discards all data coming in from the connect mode tunnel before
forwarding
it to the serial interface (generally used for debugging).
block serial disable
Forwards (tunnels) serial data in connect mode tunneling.
block serial enable
Discards all data coming in from the serial interface before for-
warding
it to the connect mode tunnel (generally used for debugging).
clrscrn
Clears the screen.
connect mode always
Enables the tunneling server to always establish tunneling con-
nections.
connect mode any character
Enables the tunneling server to establish a tunneling connection
when a
character is received on the corresponding line (serial port).
connect mode disable
Disables connect mode tunneling.
connect mode modem control asserted
Enables the tunneling server to make tunneling connections when
the modem
control pin is asserted.
connect mode modem emulation
Enables modem emulation for connect mode tunneling.
connect mode start character
Enables connect mode tunneling when the configured start char-
acter
is received on the line.
cp output
Enters the next lower level.
default connect mode
Restores the default connect mode as "disable".
default host mode
Connects to the first host in the list that accepts the connection.
default local port
Uses a random port number as the local port for establishing tun-
neling
connections to other devices.
default reconnect time
Restores the default reconnect time value for connect mode tun-
neling.
default start character
Defaults the connect mode start character.
email connect <number>
Sets an email profile to use to send an email alert upon establish-
ing
a connect mode tunnel.
PremierWave EN Command Reference 62