A SERVICE OF

logo

Open as PDF
next previous
5: Commands and Levels
ters or more for
maximum security. Spaces and punctuation characters are per-
mitted.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
suite none
Sets the security suite to None.
suite wep
Sets the security suite to WEP.
suite wpa
Sets the security suite to WPA.
suite wpa2
Sets the security suite to WPA2.
wep
Enters the next lower level.
wpax
Enters the next lower level.
write
Stores the current configuration in permanent memory.
security (config-profile-security:default_adhoc_profile) level commands
advanced
Switch to advanced level
apply wlan
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
basic
Switch to basic level
clrscrn
Clears the screen.
default key type
Restores the key type to the default value (passphrase).
default suite
Restores the security method (suite) to the default value (None).
exit
Exit to the profiles level
key type hex
Sets the key type to hex.
key type passphrase
Sets the key type to passphrase.
no passphrase
Removes the passphrase.
passphrase <text>
Sets the passphrase. Maximum 63 characters.
<text> = put quotes around characters that make up the pass-
phrase.
Please refer to the other equipment’s manual to determine the
passphrase
input style recommended.
NOTE: Lantronix recommends using a passphrase of 20 charac-
ters or more for
maximum security. Spaces and punctuation characters are per-
mitted.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
suite none
Sets the security suite to None.
suite wep
Sets the security suite to WEP.
suite wpa
Sets the security suite to WPA.
suite wpa2
Sets the security suite to WPA2.
wep
Enters the next lower level.
wpax
Enters the next lower level.
write
Stores the current configuration in permanent memory.
serial (tunnel-serial:3) level commands
clrscrn
Clears the screen.
PremierWave EN Command Reference 198