A SERVICE OF

logo

Open as PDF
next previous
5: Commands and Levels
show history
Displays the last 20 commands entered during the current CLI
session.
write
Stores the current configuration in permanent memory.
wpax (config-profile-security-wpax:test1) level commands
apply wlan
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
authentication 802.1x
Sets the authentication method to IEEE 802.1x.
authentication psk
Sets the authentication method to PSK.
clrscrn
Clears the screen.
credentials <text>
Selects the RSA certificate by configured name.
default authentication
Restores the authentication method to the default value (PSK).
default eap-ttls option
Restores the eap-ttls protocol options to the default (EAP-
MSCHAP V2).
default encryption
Restores the encryption type to the default value (none enabled).
default ieee 802.1x
Restores the default IEEE 802.1x protocol, EAP-TTLS.
default peap option
Restores the PEAP authentication protocol options to the default
(EAP-MSCHAP V2).
eap-ttls option chap
Sets the EAP-TTLS authentication protocol option to CHAP.
eap-ttls option eap-md5
Sets the EAP-TTLS authentication protocol option to EAP-MD5.
eap-ttls option eap-mschapv2
Sets the EAP-TTLS authentication protocol option to EAP-
MSCHAP V2.
eap-ttls option mschap
Sets the EAP-TTLS authentication protocol option to MSCHAP.
eap-ttls option mschapv2
Sets the EAP-TTLS authentication protocol option to MSCHAP
V2.
eap-ttls option pap
Sets the EAP-TTLS authentication protocol option to PAP.
encryption ccmp disable
Disables this encryption method.
encryption ccmp enable
Enables this encryption method.
encryption tkip disable
Disables this encryption method.
encryption tkip enable
Enables this encryption method.
encryption wep disable
Disables this encryption method.
encryption wep enable
Enables this encryption method.
exit
Exits to the next higher level.
ieee 802.1x eap-tls
Sets the IEEE 802.1x protocol to EAP-TLS.
ieee 802.1x eap-ttls
Sets the IEEE 802.1x protocol to EAP-TTLS.
ieee 802.1x leap
Sets the IEEE 802.1x protocol to LEAP.
ieee 802.1x peap
Sets the IEEE 802.1x protocol to PEAP.
key <hexadecimal>
Sets key.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punctuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains spaces.
key text <text>
Sets key.
Each byte is represented by a single character.
Note that quotes must enclose the value if it contains spaces.
no credentials
Clears the RSA certificate name.
no key
Removes key.
no password
Clears the password.
PremierWave EN Command Reference 209