182
Control systems
COMAND navigation system (entering a destination)
Entering a destination from the desti-
nation memory
̈ Select “Navi” Ǟ “Destination” Ǟ
“From Memory”.
The destination memory list appears ei-
ther with or without the input charac-
ters (
୴ page 183). Whether the input
characters appear depends on the
number of entries in the destination
memory.
Destination memory list with input
characters
When this list appears, the input charac-
ters 4 are automatically activated.
1 Top list entry based on the input data
up to that point
2 Characters entered by the user
3 Characters automatically added by the
system
4 Input characters
5 Currently non-selectable characters
6 Destination memory list
7 Currently selected character
8 Currently selectable characters
While the characters are being selected as
described below, the top list entry 1 al-
ways shows the destination which best
corresponds to the input data as it has
been entered up to that point.
At the same time, COMAND automatically
supplements characters 2 entered by the
user with appropriate characters 3.
̈ Changing language for the input
characters: Select !.
̈ Select desired language.
̈ Changing character set for the input
characters: Select #.
Depending on the previous setting, you
will change to letters with special char-
acters or to numbers with special char-
acters.
̈ Selecting characters: Slide omp or
rotate ymz.
̈ Confirming character selection:
Press n.
i
The destination memory always contains an
entry called “My Address”. You can save your
home address, for example, under this entry
(
୴ page 206).
i
In the list of input characters 4, you can
only select currently selectable characters.
Which characters are included depends on the
sequence in which you have entered your desti-
nation and the content of the destination memo-
ry.
