367
Controls in detail
Lighting
Switching on high beams
Combination switch
1 High beam
2 High beam flasher
̈ Turn the exterior lamp switch to
position B (
୴ page 363).
̈ Push the combination switch in the di-
rection of arrow 1.
The high beam indicator A in the in-
strument cluster comes on
(
୴ page 30).
̈ High beam flasher: Pull the combina-
tion switch briefly in the direction of
arrow 2.
Headlamp cleaning system
1 Headlamp washer button
̈ Switch on the ignition (୴ page 336).
̈ Press button 1 up or down.
The headlamps are cleaned with a
high-pressure water jet.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system”
(
୴ page 519).
i
The headlamps are automatically cleaned
when, at the same time,
ț the engine is running
ț the headlamps are switched on
ț the windshield wipers have wiped the wind-
shield with washer fluid fifteen times
When you switch off the ignition or press
button 1, the automatic function is reset and
will start counting the next time from the begin-
ning.
