A SERVICE OF

logo

Open as PDF
next previous
Appendix H-Restoring Defaults and System Recovery
Polycom, Inc. H-7
5 In the Initial Setup Utility window, click the Restore to Factory Defaults link.
The Restore to Factory Security Defaults dialog box is displayed.
6 Recommended: Click the Lan Configuration check box and modify the following
parameters in the utility’s dialog box using the information supplied by your network
administrator.
— Control Unit IP Address
— Subnet Mask
— Default Router IP Address
The restore to Factory Defaults removes the Management Network Service. If the above fields
addresses are not set, the Control Unit IP Address of the Management Network Service will be
192.168.1.254.