Program Field 0X06 (X = key number) for each card you want to have these
features enabled.
Field Entry
0X06 (X = key number) Enter 0, 1, 2, or 3, then press [ENTER].
0 = None
1 = Enter last 4 digits
2 = Display Mag Stripe
3 = Options 1 and 2
Note: For this application, Fraud Control has been eliminated on debit
transactions (keys 1 and 2). Locations 0106 and 0206 must be empty for
fraud control to NOT occur during a debit transaction. The operating system
will attempt to perform Fraud Control if a value is present in 0X06 and a
debit transaction is initiated. As a result, 0X06 is cleared when Debit is
selected and remains empty until a host key which has the potential for using
Fraud Control is pressed. At that time, 0X06 is updated from a value stored
during the copyright display after initial download (the value of 0106 is stored
in 0635 and the value of 0206 is stored in 0636).
Eliminating "PROGRAMING ERROR"
If your terminal displays a "PROGRAMING ERROR" message, you have two
options to attempt recovery:
1. Press the [3] and [5] keys simultaneously. The TRANZ 460 recalculates
the check sum digit that may be the cause of the "PROGRAMMING
ERROR." A new download of the application is not necessary.
2. Simultaneously press the [1] and BLUE keys until the calendar/clock
reappears on the display. A new download of the application is required.
Follow the procedures for downloading from one terminal to another on
page 4-3 or call the VeriFone Customer Support Help Desk for a
telephone download.
Password Protection
The FDC TRANZ 460 application allows you to password-protect most of the
transactions and functions. This can be accomplished via a ZONTALK
download, the Setup function, or by entering the appropriate string of 12
characters in Memory Location 0859.
The character positions in the string and corresponding transactions are as
follows:
4. General Programming
TRANZ 460 Terminal 4 - 5
