INTERFACE CONTROL - D and C
SERIES
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Shut off the gas before servicing the
unit.
1. Remove CONTROL PANEL.
2. Note lead wire locations and remove wiring.
3. Remove screws securing control to fryer and
remove.
Fig. 13
4. Reverse procedure to install and check for proper
operation.
POWER SWITCH - D and C SERIES
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
NOTE: This procedure is for solid state and computer
controls. Power switch for analog controls is part of the
analog control box.
1. Open fryer door to access power switch.
Fig. 14
2. Unplug power switch connector.
3. Reach behind power switch and press tabs on
both sides of power switch to remove switch.
NOTE: Power switch is removed from front of the
panel.
4. Reverse procedure to install new power switch.
5. Check operation of machine.
TEMPERATURE PROBE
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.
Shut off the gas before servicing the
unit.
1. Drain shortening from fryer tank.
VK and TR GAS FRYERS W/Wo KleenScreen PLUS - REMOVAL AND REPLACEMENT OF PARTS
Page 11 of 55 F45474 (0413)
