Chapter 17 Link Aggregation
GS1920 Series User’s Guide
137
17.4 Link Aggregation Control Protocol
Click Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See Section on page 133 for more information on dynamic link
aggregation.
Figure 101 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
Group Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 54 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL DESCRIPTION
