Chapter 24 AAA
GS1920 Series User’s Guide
184
describes the values you need to configure. Note that the bolded values in the table are fixed values
as defined in RFC 3580.
24.6.2 Supported RADIUS Attributes
Remote Authentication Dial-In User Service (RADIUS) attributes are data used to define specific
authentication elements in a user profile, which is stored on the RADIUS server. This appendix lists
the RADIUS attributes supported by the Switch.
Refer to RFC 2865 for more information about RADIUS attributes used for authentication.
This section lists the attributes used by authentication functions on the Switch. In cases where the
attribute has a specific format associated with it, the format is specified.
24.6.3 Attributes Used for Authentication
The following sections list the attributes sent from the Switch to the RADIUS server when
performing authentication.
24.6.3.1 Attributes Used for Authenticating Privilege Access
User-Name
- The format of the User-Name attribute is $enab#$, where # is the privilege level (1-14).
User-Password
NAS-Identifier
NAS-IP-Address
24.6.3.2 Attributes Used to Login Users
User-Name
User-Password
NAS-Identifier
NAS-IP-Address
24.6.3.3 Attributes Used by the IEEE 802.1x Authentication
User-Name
NAS-Identifier
NAS-IP-Address
NAS-Port
NAS-Port-Type
Table 78 Supported Tunnel Protocol Attribute
FUNCTION ATTRIBUTE
VLAN Assignment
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
VLAN ID
Note: You must also create a VLAN with the specified VID on the Switch.
