Chapter 31 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
255
31.8 LLDP-MED Network Policy
Click Advanced Application > LLDP > LLDP-MED Network Policy (Click Here) to display the
screen as shown next.
Figure 184 Advanced Application > LLDP > LLDP-MED Network Policy
The following table describes the labels in this screen.
Table 119 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL DESCRIPTION
Port Enter the port number to set up the LLPD-MED network policy.
Application Type Select the type of application used in the network policy.
•voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
•streaming-video
• video-signaling
Tag Select to tag or untag in the network policy.
• tagged
• untagged
VLAN Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames,
enter “0”.
DSCP Enter the DSCP value of the network policy. The value is defined from 0 through 63 with
the 0 representing use of the default DSCP value.
Priority Enter the priority value for the network policy.
Add Click Add after finish entering the network policy information. A summary table will list
all the Switch you’ve added.
Cancel Click Cancel to begin entering the information afresh.
Index
This field displays the of index number of the network policy. Click an index number to
edit the rule.
Port
This field displays the port number of the network policy.
Application Type
This field displays the application type of the network policy.
