Chapter 31 Link Layer Discovery Protocol (LLDP)
GS1920 Series User’s Guide
252
31.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP
Configuration (Click Here) > Basic TLV Setting to display the screen as shown next.
Figure 181 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
The following table describes the labels in this screen.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 115 Advanced Application > LLDP > LLDP Configuration
LABEL DESCRIPTION
Table 116 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Port This displays the port number on which you’re configuring LLDP . Select * to configure
all ports simultaenously.
Management
Address
Select to enable the sending of Management Address TLVs on the port(s).
Port Description Select to enable the sending of Port Description TLVs on the port(s).
System
Capabilities
Select to enable the sending of System Capabilities TLVs on the port(s).
System
Description
Select to enable the sending of System Description TLVs on the port(s).
System Name Select to enable the sending of System Name TLVs on the port(s).
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
