Filter
Top Products
9
Regulatory Information
EP-490
FCC ID: NNA-EP-490
IC: 3059A-EP436
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired
operation.
Privacy of communications may not be ensured when using
this phone.
1.
The term “IC:” before the radio certification number only
signifies that Industry of Canada technical specifications
were met.
2. This telephone system complies with rules of the FCC
Part 68 and Canadian IC/DOC CS-03. On the bottom of
the base station is a label that contains, among other
information, the FCC Registration Number, Ringer
Equivalence Number (REN) and the Universal Service
Order Code, which is RJ-11C in the U.S. or CA-11A in
Canada. Your telephone company may ask you for this
information.
3. The REN is useful to determine the quantity of devices
you may connect to your telephone line and still have all
devices ring when your telephone number is called. In
most, but not all, areas the sum of the REN’s of all
devices connected to one line should not exceed 5.0.
To be certain of the number of devices you may connect
to your phone line, you should contact you local
telephone company for the maximum REN in your area.
4. If your telephone equipment causes problems to the
telephone network, the telephone company may ask you
to disconnect your phone system from the line until the
10
problem has been corrected. Consult with your local
phone company for your rights if this happens.
5. Your telephone company may make changes in its
facilities, equipment, operations, or procedures that
could affect the proper functioning of your telephone
system. Consult with your local phone company for your
rights if this happens.
6. This telephone system may not be used on coin service
provided by the telephone company. Connection to
party lines is subject to state tariffs.
7. This telephone system has been tested and found to
comply with the limits for Class B digital devices,
pursuant to Part 15 of the FCC Rules and RSS210 of the
DOC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
general public installation. Operations of these devices
may still encounter interference from/to nearby TV’s,
VCR’s, radios, computers, or other electronic devices.
To minimize or prevent such interference, the telephone
system should not be placed or operated near other
electronic devices. If interference occurs, moving the
base station and the handset farther away from them will
often reduce or eliminate the interference.
8. However, there is no guarantee that interference will not
occur in a particular installation. If this telephone system
does cause interference to other electronic devices,
which can be determined by turning the system off and
on, the user is encouraged to try to correct the
interference by one or several of the following measures:
a. Increase the space separation between the handset
or base station and the device that is experiencing
interference. We recommend at least 20 feet
between the system and other electronic devices.
b. Connect the base station to a power outlet on a
circuit separate from that used by the device
experiencing interference.
c. Consult the dealer or an experienced electronic
technician for help.