Filter
Top Products
2-5
5P cables
1. Use a knife to cut intersecting slits in the rubber bushing.
2. Fabricate the cable (05S0309 or 05S0793) as shown below.
9 mm
Solder the vinyl wire to the drain wire.
Wind vinyl tape.
For 05S0793, cut the almor off at here and wind vinyl tape.
55 mm
40 mm
3. Wrap vinyl tape or attach an insulating tube to the end of the vinyl sheath to prevent the
shorting to the board.
4. Pass the 5P cable to the rubber bush, and then connect the cable to #1 to 10 on the TB
Board (05P0758).
#1 to 10
TB Board
Transceiver unit, inside view
5. Fasten the 5P cable to the fixing plate with a cable tie (local supply.)
Fixing plate
Cable tie
Fixing plate (exploded view of transceiver unit)