Filter
Top Products
2-6
How to connect cable to the terminal board
1. Press this downward by finger or screw driver.
2. Insert a core of cable.
3. Release the finger or screw driver.
Control unit
Connect the transceiver unit and the control unit by the supplied cable with D-sub 15 pin
connector for both ends. A control unit should be connected to the CONTROLLER 1 port.
When connecting two control units, the CONTROLLER 1 port has priority.
Connect the handset HS-2003 to the HANDSET 1 port at the rear of the control unit. For
other handset or microphone, connect to the HANDSET2/MIC port. Note that these two
ports cannot be used at the same time.