Filter
Top Products
3-1
3. INITIAL SETTING
After completing the installation, check all connection before applying the power.
Note: For the MMSI setting, ask your dealer.
3.1 Performance Check
Receiver
1. Set the unit as follows.
a) Speaker: ON
b) Squelch: OFF
c) AGC: FAST
d) Sensitivity: Max
2. Confirm that a signal can be received on each band. If noise or signal is weak, check
the antenna lead-in section, coaxial cable connection and ground connections.
Transmitter
1. On each band, confirm that the antenna is automatically tuned when the LOG/TUNE
key is pressed. Automatic tuning time of the antenna should take no longer than 15
seconds to tune. If more than 15 seconds, re-check antenna length.
2. Communicate with the handset, confirming that antenna current (IA) changes with voice
level.
3.2 Initializing Control Unit and Transceiver Unit
The control unit is commonly used with the transceiver unit of FS-1570, FS-2570 and
FS-5070. Therefore, initialize the units at installation as follows.
1. Turn on the power switch on the control unit. A while later, the radiotelephone (RT)
screen appears.
2. Open the transceiver unit and press the reset switch S1 on the T-CPU board 05P0732.
05P0732B
T-CPU