Filter
Top Products
42 Using Voice Recognition
–Say “Clear” to erase the last digit entered.
The phone responds: “Digit cleared.”
To clear the entire phone number, say “
Clear”
again. When the phone prompts you with “Clear
entire phone number?”, say “
Yes” to clear or
“
No” to cancel.
–Say “
Call” to dial the number.
–Say “
Verify” to cause phone to repeat the set of
digits that you input.
–Say “
Cancel” to exit voice recognizer and return
to the main screen.
– Speak a digit to enter the next digit. Once the
phone repeats the digit, you can speak the next
digit or pause to hear the prompt.
Using voice features
You can use voice commands to make a phone call or to
answer the phone only if your phone is connected to the
AC adaptor.
Waking up the phone
If your phone is connected to a Kyocera hands-free
headset, you can use the voice command to activate the
phone to make a phone call.
To activate the Voice wake-up setting:
•Select
Menu → Settings → Voice Services →
Voice wake-up → Enabled with ext. power.
To wake up the phone:
1. Say “Wake up” and listen for a tone.
2. Say “Wake up” again until you hear two tones.
Answering the phone
You can set your phone to (1) answer automatically or
(2) answer using a voice command.
Answering automatically
You can set your phone to answer automatically.
Note: This setting also works with the portable hands-
free headset.
•Select
Menu → Settings → Accessories →
Auto Answer → After 5 seconds.
Answering using voice commands
If Auto Answer is turned off, you can use a voice
command to answer an incoming call when using a
hands-free headset.
•Select
Menu → Settings → Accessories →
Auto Answer → Disabled.
82-G1858-1EN.book Page 42 Tuesday, April 3, 2007 11:41 AM