Filter
Top Products
Turning Your Phone On and Off
Turning Your Phone On
To turn your phone on:
ᮣ
Press and hold for approximately two seconds.
Once your phone is on, it may display “Searching for Service,” which
indicates that your phone is searching for a signal. When your phone
finds a signal, it automatically enters standby mode – the phone’s idle
state. At this point, you are ready to begin making and receiving calls.
If your phone is unable to find a signal after 15 minutes of searching, a
Power Save feature is automatically activated. When a signal is found,
your phone automatically returns to standby mode.
In Power Save mode, your phone searches for a signal periodically
without your intervention. You can also initiate a search for Sprint PCS
Service by pressing any key (when your phone is turned on).
Turning Your Phone Off
To turn your phone off:
ᮣ
Press and hold for two seconds until you see the powering
down animation on the display screen.
Your screen remains blank while your phone is off (unless the battery
is charging).
END
Tip:
The Power Save feature helps to conserve your battery power when
you are in an area where there is no signal.
END
Section 2A: Your Sprint PCS Vision Phone – The Basics 15