Filter
Top Products
11
BASIC FUNCTIONS
RECEIVING A CALL
³ Press any key except ON or the volume keys.
An incoming call is indicated by a ringing tone, and
the
CALL
message flashing on the display.
If the
SILENT SERVICE
option (Menu 6) has been
selected there will be no ringing tone; the keypad and
display lights will flash instead, and only a short beep
will be heard (refer to ‘Ringing volume (Menu 6)’,
page 37).
If you do not answer a call, the
CALL
message will
remain on the display (indicating a missed call); to
clear the display, press any key.
‘Any-key answering’ facility: Any key (except ON or
the volume keys) may be pressed to answer a call
(except when ‘keyguard’ is active). If ‘keyguard’ is
active, you must press the SEND key to answer the
call. If you receive a call while entering a number, the
call will be answered on the first keypress after the
ringing starts.
· To end the call, press END.
MAKING A CALL
³ For best reception, pull the
antenna up to extend fully. Do not
leave the antenna partly extended.
· Open the keypad cover. Enter the
number you wish to dial. Remember
to include the area code (if this is
necessary on your system) even if you
are making a local call. The number will
be displayed.
» To correct a mistake, press CLR to delete the last
digit, or press and hold CLR to clear the whole
display (then re-enter the number).
¿ Press SEND. The
IN USE
indicator will appear on
the display, and the number will disappear when
the call is connected.
´ To end the call, press END.