Filter
Top Products
6 Video quality indicator. To
change this setting, select
Options
> Settings
> Video quality.
7
Video clip file type
8
Available recording time. Wh
en you are recording, the
current video length indicator also shows the elap
sed
and remaining time.
9
The location to which the video clip is saved.
Record videos
1 If the camera is in the im
age mode, select the video
mode from the active toolbar.
2 To start recording, press the capture key. The red
record icon (
) is displayed and a tone sounds.
3 To pause recording at any time, press
Pause
. Select
Continue to resume. If you pause recording and do
not press any key within one minute, the recording
stops.
To zoom in or out of the subject, use the zoom key in
your device.
4 To stop recording, press the capture key. The video clip
is automatically saved in Photos. The maximum lengt
h
of a video clip is approximately 30 seconds with
sharing quality and 90 minutes with other quality
settings.
To activate the front camera, select
Options >
Use
secondary camera
. To start recording a video, press the
scroll key. To zoom in or out, scroll up or down.
Camera settings
There are two kinds of settings for the camera: se
tup
settings and main settings. The setup settings return
to
the default settings after you close the camera, but the
main settings remain the
same until you change them
again. To adjust the setup se
ttings, use the options in the
active toolbar.
See "Colour and lighting settings"
, p.
31
.
To change the main settings, in the image or video mode,
select Options
> Settings
.
Still image camera settings
To change the main settings
, in the image mode, select
Options
> Settings
and from the following:
Image quality
— Set the resolution (main camera only).
The better the image quality,
the more memory the image
consumes.
Show captured image
— Select whether to view the
captured image after it is taken or to continue image
capturing immediately.
Default image name
— Define the default name for the
captured images.
Extended digital zoom
— The setting is only available
in the main camera.
On (continuous)
allows the zoom
increments to be smooth and continuous between dig
ital
and extended digital zoom,
On (paused)
allows the zoom
increments to pause at the
digital and extended digital
step point, and
Off allows a limited amount of zoom while
retaining the image resolut
ion. Use the extended zoom
only when getting closer to the subject is more importan
t
than the final image quality.
The overall quality of a
30
Camera
© 2009 Nokia. All rights reserved.