Filter
Top Products
Installation
33
Remote control CU-13R
The remote control should be located so that it is within easy reach of
the user. Do not mount the remote control within the head impact area.
When installing the remote control, make sure it does not interfere with
or hinder the steering or other controls or systems used in the operation
of the vehicle (for example, airbags).
You can attach the remote control to the steering wheel, or mount it to
the dashboard or the console between the driver’s and front passenger's
seat.
Mount using the supplied tape on the dashboard or console
1. Attach the supplied tape pad to the desired location in the car: peel
off the protective sheet from the bigger pad, and press the pad into
place.
When you peel off the protective sheet, do not touch the adhesive
side with your finger. Make sure the surface where you attach the
pad is dry and free from dirt and dust.
2. Peel off the protective sheet from the smaller pad, and attach the
pad to the bottom of the remote control. Do not cover the battery
cover of the remote control.
3. Press the pads firmly against each other, and check that the remote
control stays securely in place.
Mount to the steering wheel using the supplied strap
Install the remote control to the inside of the steering wheel. Do not
install the remote control to the centre or outside of the steering wheel.
1. Wrap the strap around the steering wheel (not shown in the figures).
2. To open the catch indicated with an arrow, pull the catch (1), and
thread the strap through the opening (2).