Filter
Top Products
Installation
39
Check the correct location of the mute signal for the car radio,
and connect the configuration connector "Mute" to the
corresponding socket (Mute1, Mute2, or Mute3). By default, the
mute connector is connected to the ISO connector pin A2
(Mute2). If the car radio does not support the mute function,
leave the connector unconnected.
Plug the two ISO male connectors to the car radio.
2. Insert the speaker and power cable plugs of the ISO cable to the
respective connectors on the junction box.
3. Connect the display to the respective connector on the junction box.
Optional steps:
• To charge a compatible mobile device through the car kit, connect a
compatible charging cable (such as Nokia CA-134) to the junction
box.
• To use an external microphone (such as Nokia MP-2) instead of the
built-in one, connect the microphone to the respective connector on
the junction box, and modify the microphone settings (see “Installer
settings”, p. 43). In noisy car environments, you may need to use an
external microphone.