Filter
Top Products
Installation
38
Installation using the ISO cable CA-160
When you connect the car kit to the car radio system with the ISO cable
CA-160, the car radio is muted when you make or receive a call.
1. To connect the ISO cable to the car radio:
• Disconnect the two ISO plugs from the car radio for power and
loudspeakers.
• Connect the female connector of the ISO cable to the power and
speaker connectors of the car wiring harness.
• Check the permanent +12 V feed (red wire) and ignition feed
(blue wire) on the junction box connector. If necessary, swap the
configuration connectors "+12V battery" and "Ignition" of the
ISO cable.
CA-160
CK-200
CA-134