Filter
Top Products
Tools
97
Copyright © 2005 Nokia. All rights reserved.
Message text - Write a text to be sent in a text message when you reject a call.
Image in video call - You can deny video sending when you receive a video call. Select a
still image to be displayed instead of video.
Tip! To change the
settings for call diverting,
press and select
Tools→ Settings→ Call
divert. See Call diverting
,
p. ’104’
.
Automatic redial - Select On, and your phone will make a maximum of ten attempts to
connect the call after an unsuccessful call attempt. Press to stop automatic redialling.
Summary after call - Activate this setting if you want the phone to briefly display the
approximate duration of the last call.
Speed dialling - Select On, and the numbers assigned to the speed dialling keys ( -
) can be dialled by pressing and holding the key. See also Speed dialling a phone
number, p. ’22’.
Anykey answer - Select On, and you can answer an incoming call by briefly pressing any
key, except , , , and .
Tip! To switch
between the phone lines,
press and hold in
standby mode.
Line in use (network service) - This setting is shown only if the SIM card supports two
subscriber numbers, that is, two phone lines. Select which phone line you want to use for
making calls and sending text messages. Calls on both lines can be answered irrespective
of the selected line. If you select Line 2 and have not subscribed to this network service,
you will not be able to make calls. When line 2 is selected, is shown in the standby
mode.
Line change (network service) - To prevent line selection, select Line change→ Disable if
supported by your SIM card. To change this setting, you need the PIN2 code.
Connection settings
Data connections and access points
Your phone supports packet data connections ( ), such as GPRS in the GSM network. See
also Essential indicators
, p. ’15’. To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
R0915_en.book Page 97 Tuesday, February 8, 2005 11:46 AM