Filter
Top Products
31
Note:
You can also press the keypad number key that corresponds to the menu
option number.
Finding a Contacts Entry
Voice Method
Use the VoiceSignal Lookup command to view contact
information for any named contact stored in your Contacts list by
saying the name.
Note:
The
Lookup
command shows the requested contact information in the
display but does not dial any phone numbers for the contact.
To look up information for a specific contact:
1. In standby mode, press and hold the key to launch
VoiceSignal.
“
Say a Command
” appears in the display and is
pronounced through the speaker.
2. Say “
Lookup
”.
VoiceSignal prompts you to “
Say the name.
”
3. Speak clearly and say the full name of the person you
want to call, exactly as it is entered in your Contacts list.
•
If VoiceSignal recognizes the name you said, the Contact entry
information for that name appears in the display.
•
If VoiceSignal does not recognize the name you said, a choice list of
up to three names appears in the display, and VoiceSignal prompts
you with “
Did you say?
” followed by the first name on the list.
4. Say “
Yes
” to confirm the name or “
No
” to hear the next
name, or use the keypad to select the correct name
from the list. (For more information, refer to “Choice
Lists” on page 59.)
•
To say the name again, press
Repeat
.
•
To exit VoiceSignal without dialing, press
Settings
and press
Exit
.
5. The contact information for the name you selected
appears in the display.
•
Press to dial the number associated with the name.
•
Press
Erase
to remove this entry from your Contacts list.
•
Press the
EDIT
key ( ) to add or change information for this
entry.
•
Press
Options
and the following options pop-up in the display:
–
Send Txt Msg
— Create and send a text message to the selected
Contact.
–
Call
— Dial the number associated with the name.
–
Send Name Card Via Bluetooth
— Allows you to send a
message to the selected entry which contains the information from
an name entry which you have on file.
Use the Navigation key to highlight an option, then press the
key. The highlighted option’s sub-menu appears in the display.