Filter
Top Products
Health and Safety Information 110
Note:
For safety, do not handle a damaged or leaking LiIon battery.
Acknowledging Special Precautions and Industry Canada Notice
Cautions
Any changes or modifications to your phone not expressly approved in this document could void your warranty for this
equipment, and void your authority to operate this equipment. Only use approved batteries, antennas and chargers.
The use of any unauthorized accessories may be dangerous and void the phone warranty if said accessories cause
damage or a defect to the phone.
Although your phone is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting,
bending or sitting on it.
Information to User
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
•
Reorient / relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rates (SAR) for Wireless Phones
The SAR is a value that corresponds to the relative amount of RF energy absorbed in the head of a user of a wireless
handset.
The SAR value of a phone is the result of an extensive testing, measuring and calculation process. It does not
represent how much RF the phone emits. All phone models are tested at their highest value in strict laboratory
settings. But when in operation, the SAR of a phone can be substantially less than the level reported to the FCC. This
is because of a variety of factors including its proximity to a base station antenna, phone design and other factors.