Filter
Top Products
Section 2L: Using SprintPCS Ready Link 239
Receivinga SprintPCS Ready Link Call
To receive a Sprint PCS Ready Link call:
1. Make sure your phone’s Sprint PCS Ready Link mode is
enabled (see “Setting SprintPCS Ready Link Mode”on
page 230).
2. When you receive a SprintPCS Ready Link call from a
contact, “R-Link Call,”the contact’s name, and the
Sprint PCS Ready Link number appear on the display.
(You do notneed to take any action to answer the call.)
Ⅲ
When you receive a group call, “Group Call,”the
group member’s name, and the Sprint PCS Ready
Link number appear.
3. If the person placing the call has keptthe floor (held the
Ready Link/Recorder button), you will see the contact
name and Sprint PCS Ready Link number along with “has
floor,”and you will hear the caller speaking.
4. When the caller finishes speaking and releases , you
will see “Floor is open.”on the display screen. Press and
hold to take the floor and reply to the caller. (You
will see “You have floor.”and hear a tone confirming that
you may speak.)
5. When the conversation is finished, press .
Tip:You can also receive a SprintPCS Ready Link call with the flip closed. Press
and hold the Ready Link button to take the floor when the floor is open.
Note:You can change the volume and the speaker setting during a
SprintPCS Ready Link call. Volume:Adjust the voice volume by using the Side
Volume key or by pressing the navigation key up or down exceptwhen you
are pressing and holding the Ready Link button. Speaker:Switch the speaker
on or off by pressing the Speaker button ( ).
SprintPCS Ready Link