Filter
Top Products
Not for commercial use – Ericsson Inc.
9RLFH2SHUDWLRQ
$QVZHULQJ&DOOV
When your phone receives a call, the ringer sounds, Incoming
Call appears in the display, and the display and keypad backlight
illuminate. You can temporarily silence the ringer by pressing
12
or
the upper or lower side keys, and still answer the call by pressing
<(6
. If you have Caller Number Identification (Caller ID) service
from your service provider, the caller's phone number, or the
corresponding Phonebook name, is shown in the display.
Answer the phone by pressing
<(6
. For information on adjusting
your answering preferences, see “Answer Option” on page 24.
Incoming Call is replaced by the call timer display once the call
is answered. End the call by pressing
12
.
&DOO:DLWLQJ
If you have call waiting service from your service provider, press
<(6
to answer a call when you receive the call waiting signal. You can
switch between the two calls by pressing
<(6
.
Note! Do not press
12
until you are ready to end both calls.
8QDQVZHUHG&DOOV
Your Incoming Calls shows the number of calls you have received
but did not answer. Press
<(6
from the Missed Calls Indicator screen
to access Incoming Calls.
You can clear the number of missed calls from the display by pressing
any key except
<(6
. If Caller Number Identification is available from
your carrier, unanswered calls will be stored in the Incoming Calls
of the CALL INFO menu. Press
<(6
from the Missed Calls
Indicator screen to access the Incoming Call Log, or access the log in
the CALL INFO menu. The icon indicates a missed or
unanswered call.
7HPSRUDULO\0XWLQJWKH5LQJ7RQH
To temporarily mute the ring tone without answering the call, press
12
or the up or down side volume keys. Incoming Call is still
shown in the display, and you can still answer the call by pressing
<(6
. For information on adjusting your answering preferences, see
“Answer Option” on page 24.
&DOOHU1XPEHU,GHQWLILFDWLRQ
If your service provider has Caller Number Identification (Caller ID)
service, your phone shows the phone number of an incoming call in
the display. If the number is one that you have stored in your
phonebook with a name, the name and phone book position is
shown when your phone rings. If the Caller ID information is not
available, the message NO ID is shown in the display. The word
Anonymous may be shown if the Caller ID is restricted by the
service provider or by the caller.
0XWLQJWKH0LFURSKRQH'XULQJD&DOO
To mute the microphone during a call, press and hold the
%$&.
key.
Mic Muted appears in the display when the call is muted. Repeat
this procedure to unmute the microphone.
Note! You cannot mute the microphone during an emergency call.
'LWWR/LQGDERRN3DJH:HGQHVGD\1RYHPEHU30