Filter
Top Products
GETTING STARTED [14]
www.uniden.com
Register the Handset
If you purchase an expansion handset, you need to register the handset before use.
Only one handset can be registered at a time.
Handsets supplied with the phone are registered to the base by the factory. When
charged, pre-registered handsets display a handset ID number. Handsets that have
not been registered display
Models vary! Charge handset on the base for
registration or refer to Owner's Manual.
When you register an extra handset to
the base, the handset ID will be assigned.
For the DCX700 expansion handset
1) Before registering the extra handset, the battery
pack MUST be charged for 15-20 hours.
2) Place the extra handset in the main base unit to
begin registration.
3) While the handset is registering,
Handset
Registering
will appear in the LCD. When
Registration Complete
is displayed, the handset has
been registered to the base. If
Registration Failed
appears, please try these steps again.
For the DCX640 expansion handset (DCT7 series-
compatible model)
1) Disconnect the AC adapter.
2) While holding find hs/ and on the base,
connect the AC adapter.
Keep pressing find hs/ and on the base until
the CHARGE LED starts to blink.
3) On the handset, press and hold # until you hear beep.
Your phone may be
compatible with other
Uniden 2.4GHz Digital
Expandable Systems.
Please visit our website
at www.uniden.com for
model number
confirmation or call our
customer service at
(800) 297-1023.
note
GETTING STARTED
UP720.book Page 14 Tuesday, July 6, 2004 10:55 AM