Filter
Top Products
GETTING STARTED [24]
www.uniden.com
Setting the Dial Mode
Dial Mode sets the dial mode to tone or pulse. Most phone systems use tone dialing;
the default setting is tone dialing. Set the dialing mode to match the dialing
system used by your local phone service.
• If you are not sure of your dialing system, make a trial call. If the call connects, leave the
setting as is; otherwise set the unit to pulse dialing.
• If your phone system requires pulse dialing and you need to send DTMF tones in certain
situations during a call, you may switch over to tone dialing (refer to "Tone Dialing
Switch-over" on page 32).
1)Press menu/clear. Select the Global Setup menu, and
then the Dial Mode submenu.
2) Press /vol/
∧ or /vol/∨ to select
Tone
or
Pulse
(the initial setting is Tone).
3) Press select/ /audio tone. You will hear a confirmation tone.
&KCN/QFG
6QPG
2WNUG
GETTING STARTED
UP720.book Page 24 Tuesday, July 6, 2004 10:55 AM