4600 Series IP Telephone Installation Guide
Static Addressing Installation
3-4
4. Enter the appropriate value for the port number followed by the # button.
The following message is displayed:
where “nnn.nnn.nnn.nnn” is the value of the Gateway/router IP address.
5. Enter the IP address of the Gateway/router followed by the # button.
The following message is displayed:
where “nnn.nnn.nnn.nnn” is the value of the IP netmask.
6. Enter the IP netmask followed by the # button.
The following message is displayed:
where “nnn.nnn.nnn.nnn” is the value of the TFTP server IP address.
7. Enter the IP address of the TFTP server followed by the # button.
The following message is displayed:
8. Press the # button to save the new values you have entered.
The following message is displayed:
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the TFTP server after you enter static addressing
information, you will need to reenter your static addressing information.
QOS Option Setting
3
Administering QOS options is not mandatory, but it is highly recommended.
Use the following procedure to set Quality of Service (QOS) options.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate of
the telephone:
Hold 7 6 7 # (Hold Q O S #)
Router=nnn.nnn.nnn.nnn
New=_
or
nnn.nnn.nnn.nnn
Router=_
Mask=nnn.nnn.nnn.nnn
New=_
or
nnn.nnn.nnn.nnn
Mask=_
FileSv=nnn.nnn.nnn.nnn
New=_
or
nnn.nnn.nnn.nnn
FileSv=_
Save new values?
*=no #=yes
New values
being saved
