4600 Series IP Telephone Installation Guide
Scenarios for the Restart Process
A-2
Boot file Needs to be Upgraded
4
1. The following message is displayed:
2. While the hardware is being initialized, the following message is displayed:
3. While either the application file (if there is one) or the boot code is uncompressed into RAM,
the following message is displayed:
Since this takes a while, asterisks, then periods, then asterisks are displayed on the second
line to indicate that something is happening.
4. When control is passed to the software that was just loaded, the following message is
displayed:
5. The telephone detects and displays the speed of the Ethernet interface in Mbps (that is, 0, 10
or 100). The message No Ethernet is displayed until the software determines whether the
interface is 10 Mbps or 100 Mbps.
If this condition applies See
Boot file Needs to be Upgraded page A-2
Latest Boot File Loaded/No Application File or Application File Needs to be
Upgraded
page A-5
Latest Boot File and System-Specific Application File Already Loaded page A-6
This should almost never happen.
Restarting...
Initializing
Loading
....************
Starting...
The Ethernet speed indicated is the LAN interface speed for both the telephone and
any attached PC.
