Figure FPD-1
Included in the initial turn-on message will be the “Rev” number for the software that operates the
5.0. It is a good idea to note the software version that is installed in your unit in the place provided
in Appendix B. Although it is unlikely that you will encounter problems with the 5.0, the exact revi-
sion number of the software installed in your system is a valuable diagnostic tool that may be helpful
to Customer Service representatives when you contact Citation via letter, phone or e-mail.
After a brief display of the main turn-on message, the displays will then indicate the factory default
input (Figure OSD-2 and FPD-2), and then go blank.
Figure OSD-2
Figure FPD-2
Speaker Setup
The first step in the configuration is to program the 5.0 so that it “knows” what kind of speakers are
connected. This information, pertaining to the number and type of speakers installed, not their
brand or model, establishes the bass management for the 5.0.
To begin the process, press the Menu button
˙
and note that the Main Menu (Figure OSD-3) will
appear. Please note that system response to programming commands is slow due to the large size of
the program in the 5.0’s microprocessor.
Figure OSD-3
Press the
¤
Menu Control button five times until the words Speaker Setup are highlighted
on the screen. Press the
›
Menu Control button to go to the Speaker Setup menu (Figure
OSD-4).
Main Menu
<Exit Menus <
Remote Zone >
Customize Modes >
Edit Watch List >
Edit Listen List >
Speaker Setup >
Program Setup >
System Options >
System Reset >
Pro
g
7 : DVD
*Pro Lo
g
ic* Vol=49
WATCH
Prog 1 : LD analog
PRO LOGIC
Volume = 03
Citation 5.0
Rev X.XX RESET
32
System Configuration
