40
System Configuration
The last item on the Program Setup menu determines whether either or both triggers are activated
when the program is selected. Press the
¤
Menu Control button one more time, and use the
‹
or
›
Menu Control buttons to determine trigger status. If you wish to have either trigger acti-
vate for certain, but not all, sources, the Power option for trigger programming must be turned
OFF in the System Options sub-menu titled Program Triggers.
As described earlier, a typical use for Trigger 1 is to turn on audio power amplifiers. If you are using
power amplifier(s) which may be controlled by 6- to 12-volt trigger signals (see the Specifications
section on page 69), Trigger 1 would be set to be ON for all programs.
Typical uses for Trigger 2 would be the control of devices associated with video sources. These
include motorized screens and light-control devices such as electrically-operated blinds or shades. If
this is what a Trigger 2 will be used for in your installation, it would be set to ONonly in programs
with which a video source is associated, and would be left OFF in audio-only programs.
System Options
There are a number of secondary system controls, many of a “housekeeping” nature, whose settings
are normally set only once, at the time of installation. These are set at the factory to suit the needs of
most users, and need not be adjusted unless you wish to change one or more settings. These adjust-
ments are grouped in the “System Options” menu.
If you do not need to change the details of the on-screen video display, are not adding infrared sen-
sors to the system, how loud the system is when it is turned on or set to Mute, or the operation of
the two trigger outputs, you may now turn to “Operating the Citation 5.0” on page 44. You may
always return to these adjustments at a later time, should you decide to change one or more settings.
To enter the System Options menu, press the Menu button
˙
and then the
¤
Menu Control button
seven times, or press the
⁄
Menu Control button once, until the words System Options are
highlighted. Press the
›
Menu Control button once, and the SYSTEM OPTIONS menu will appear
(Figure OSD-10). As each setting is adjusted, you may proceed to the next one or exit the menus by
pressing the Menu button
˙
until you reach the Main Menu, and pressing Menu once more.
Figure OSD-10
The first menu listing refers to the position of the on-screen video display on your video monitor.
Press either the
‹
or
›
Menu Control buttons to select whether the display will appear at the TOP,
MIDDLE, BOTTOM, or will not appear (OFF).
Note: Choosing OFF will immediately blank the on-screen video display, and you will have
to use the front panel display to continue. Or, if no other menu control buttons have been
pressed, simply depress either the
‹
or
›
Menu Control button once; the on-screen display
will reappear.
System Options
< Main Menu <
OSD Position BOTTOM
Video Standard NTSC
IR Mode FRONT
Power On Vol 03
Mute Volume 00
Owner Citation
Program Triggers >
