Citation Stereo Receiver Manual

Open as PDF

next previous

• Stereo reproduces the front left and right channels through those speakers only.

• Mono invokes enhancement circuitry which create an enveloping soundﬁeld from a monophonic

input signal; it can be a signiﬁcant improvement when watching movies with mono sound.

Once you have selected a mode to customize, you will ﬁnd many of the same attributes listed which

may be modiﬁed to your preference as were associated with analog modes.

Two different attributes which may be modiﬁed are the last two on the menu (Figure OSD-30).

They are Subs Level and Auto Mode Sel.

• Subs Level gives the user the ability to raise or lower the sound level coming from the sub-

woofer(s) when a particular mode is chosen. Use the

›

‹

Menu Control buttons to raise or

lower the subwoofer level as desired.

• Auto Mode Sel(ect), when turned off, will mute the 5.0 if the signal is of a type other than

selected on the MODE line above. For example, if, on the MODE line, DTS has been selected and a

Dolby Digital source is fed to the 5.0, it will mute until either a DTS signal is supplied or another

mode is selected.

Remote Zone

If you have connected an ampliﬁer, remote infrared sensor and video monitor to the appropriate rear

panel connections of the 5.0, people in a secondary location in your home will be able to select signal

sources and volume levels independent of what is selected in the primary zone. It is not necessary for

the 5.0 to be turned on; power (for the 5.0) can also be controlled from the second zone.

It will be necessary to equip the remote zone with its own remote control, as all selections are made via the

controls under the Secondary Control Cover on the remote.

Setting Up the Remote Zone

The various options available to conﬁgure the remote zone are accessed through the Remote Zone

menu. Press the Menu button

on the remote control, and then press the

Menu Control button

once to highlight Remote Zone. Press the

›

Menu Control button to display this menu

(Figure OSD-31).

Figure OSD-31

Lines 1 through 6 of this menu allows the selection of which video source will be associated with the

analog (only) audio source in the remote zone. Press the

Menu Control button to highlight

Input-1. Then press the

›

Menu Control button to select which video source (composite video

sources 1 through 6, and/or S-video sources 1 and 2) will be associated with this analog input in the

remote zone only; it may be associated with another video source in the main zone. Select a video

source for each analog audio source to be accessed in the remote zone; for music-only sources, select

a video input which is not connected to a video source.

Remote Zone

< Main Menu <

1: Input1 COMP1

2: Input2 COMP2

3: Input3 COMP3

4: Input4 COMP4

5: Input5 COMP5

6: Input6 COMP6

Rem Zone Msgs ON

Output Mode Variable

Advanced Features