Operating the Citation 5.0
After installing and configuring the Citation 5.0, and making any desired initial settings, normal
operation is a simple matter, thanks to its powerful microprocessor and a sophisticated remote con-
trol that allows most changes to be accomplished by pressing one button. Please note, however, that
due to the large number of functions and features controlled by the system microprocessor, there will
occasionally be slight delays in executing commands you have given it, not unlike those experienced
when using a computer.
Turning On and Off
The Master Power button
1
should remain in the ON position under normal circumstances.
Simply press it in until you hear a click, and release. A green Standby LED
6
will illuminate,
indicating the 5.0 is in its Standby mode, and is ready to operate.
The 5.0 may be turned fully on by either pressing the large Standby button
2
just above the Master
Power
button
1
on the front panel, or by pressing either the Watch button
ç
or the Listen button
ƒ
on the remote control. Pressing any of the six Analog Input or six Digital Input direct-address buttons
under the sliding door on the remote control will also turn the 5.0 on, while selecting the program
whose number was pressed. Note that pressing the Standby button
å
on the remote control WILL
NOT turn the 5.0 on, although it will return it to the Standby condition when your listening or viewing
session is completed.
As the 5.0 turns on, the word in the Power Indicator
5
on the front panel will
glow a soft blue, the green standby indicator will extinguish, and a welcome screen (Figure OSD-16)
will briefly appear on the video screen, if it is on. A similar display will also appear on the front panel
(Figure FPD-1), changing in a few seconds to a status report (Figure FPD-2) indicating the program
selected, its source, the Surround mode selected and present volume setting.
Figure OSD-16
Figure FPD-1 Figure FPD-2
To put the 5.0 back in the Standby mode, either press the front panel Standby button
2
or press
the Standby button
å
on the remote control. A message of POWER OFF STANDBY will
appear briefly both on the on-screen display (Figure OSD-17) and the front panel display (Figure
FPD-3). The Power Indicator
5
will go out, and the green Standby LED
6
will light.
Pro
g
7 : DVD
*Pro Lo
g
ic* Vol=49
CITATION 5.0
Audio Video Processor
xx.xx
OWNED BY
Citation Consumer
44
Operating the Citation 5.0
