Installing System Components 141
5
Remove the fan modules. See "Removing a Cooling-Fan Module" on
page 136.
6
Remove the fan cage. See "Removing the Fan Cage" on page 138.
7
Remove the plastic filler plug for the iDRAC6 Enterprise port from the
system back panel. See "Back-Panel Features and Indicators" on page 20 for
the port location.
8
Install the iDRAC6 Enterprise card:
a
Angle the card so that the RJ-45 connector fits through the back-panel
opening.
b
Align the front edge of the card with the two front plastic retention
standoffs near the iDRAC6 Enterprise card connector on the system
board. See Figure 6-1 for the location of the connector.
c
Press the card down until it is fully seated. See Figure 3-26.
When the front of the card is fully seated, the plastic standoff tabs
snap over the edge of the card.
9
Install the fan cage. See "Installing a Fan Cage" on page 139.
10
Install the fan modules. See "Installing a Cooling-Fan Module" on
page 137.
11
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 88.
12
Close the system. See "Closing the System" on page 86.
13
Place the system upright and on its feet on a flat, stable surface.
14
Rotate the system feet outward.
15
Reattach any peripherals and connect the system to an electrical outlet.
16
Turn on the system and attached peripherals.
book.book Page 141 Monday, June 15, 2009 11:33 AM
