About Your System 55
Warning Messages
A warning message alerts you to a possible problem and prompts you to
respond before the system continues a task. For example, before you format a
diskette, a message will warn you that you may lose all data on the diskette.
Warning messages usually interrupt the task and require you to respond by
typing y (yes) or n (no).
NOTE: Warning messages are generated by either the application or the operating
system. For more information, see the documentation that accompanied the
operating system or application.
Warning!
Unsupported
memory
configuration
detected. The
memory
configuration is
not optimal. The
recommended
memory
configuration
is:
<message>
Invalid memory
configuration. The system
will run but with reduced
functionality.
Ensure that the memory
modules are installed in a
valid configuration. See
"General Memory Module
Installation Guidelines" on
page 98. If the problem
persists, see
"Troubleshooting System
Memory" on page 167.
Write fault
Write fault on
selected drive
Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard-
drive subsystem.
Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected.
See "Troubleshooting a USB
Device" on page 160,
"Troubleshooting an Optical
Drive" on page 171, and
"Troubleshooting a Hard
Drive" on page 174.
NOTE: For the full name of an abbreviation or acronym used in this table, see the
"Glossary" on page 195.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 55 Monday, June 15, 2009 11:33 AM
