Installing System Components 97
6
Remove the three shoulder screws from the old drive or the drive blank.
See Figure 3-10.
7
Attach the three shoulder screws to the drive, one screw on the lower front
screw hole on the right side and two screws on the lower screw holes on the
left side. See Figure 3-10.
Figure 3-10. Installing Optical or Tape Drive Shoulder Screws
8
From the front of the system, align the shoulder screws with the slots in
the chassis and slide the drive into the drive bay until the shoulder screws
snap into place. See Figure 3-9.
9
Attach the power and data cables to the drive.
10
Close the system. See "Closing the System" on page 86.
11
Replace the front bezel. See "Installing the Front Bezel" on page 85.
12
Place the system upright and on its feet on a flat, stable surface.
13
Rotate the system feet outward.
14
Reattach any peripherals and connect the system to an electrical outlet.
1 shoulder screws (3)
1
book.book Page 97 Monday, June 15, 2009 11:33 AM
