ENGLISH
Remote
Control
Playback
(Advanced)
Connections
Simple
Version
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
1
Connect the setup microphone.
The following screen is displayed.
1 2 3 4 5 6
Speaker Assign
RETURN
Auto Setup Start
STEP1 Preparation
In a typical setup, select "Auto Setup Start". When
connecting speakers in a setup other than 2ch/2.1ch/5.1ch,
select "Speaker Assign".
Start Auto Setup
Enter Cancel
AUDYSSEY AUTO SETUP
2
Select “Speaker Assign” and then
press ENTER.
1 2 3 4 5 6
Speaker Assign
RETURN
Auto Setup Start
STEP1 Preparation
IIn a typical setup, select "Auto Setup Start". When connecting
speakers in a setup other than 2ch/2.1ch/5.1ch, select
"Speaker Assign".
Select speaker configuration
Enter Cancel
AUDYSSEY AUTO SETUP
3
Select the conguration of the
connected speakers, and then press
ENTER.
1 2 3 4 5 6
Speaker Assign
RETURN
Auto Setup Start
STEP1 Preparation
Connect the speakers and place them according
to the recommendations in he manual.
Set the following items
if nesessary.
Select speaker configuration
EnterUp/Down Cancel
AUDYSSEY AUTO SETUP
5.1CH
Speaker Assign
2.0CH/2.1CH
5.1CH + Surround Back
5.1CH + Front Height
Use pre-out for surround back
Enter Cancel
RETURN
5.1CH
Connect 5.1-channel speakers.
2.0CH/2.1CH
Connect the front speakers and
subwoofer only.
5.1CH +
Surround Back
Connect the surround back
speakers to the PRE OUT
connectors.
5.1CH +
Front Height
Connect the front height
speakers to the PRE OUT
connectors.
4
Select “Auto Setup Start” and then
press ENTER.
Proceed to page 7
“
STEP1 Preparation
” Step 4.
NOTE
The “FIRST SETUP” screen is displayed
only when the power is first turned on after
purchase.
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
•
•
Speakers
Carefully check the left (L) and
right (R) channels and + (red)
and – (black) polarities on the
speakers being connected to this
unit, and be sure to interconnect
the channels and polarities
correctly.
Connecting the speaker
cables
Peel off about 10 mm of
sheathing from the tip of the
speaker cable, then either
twist the core wire tightly or
terminate it.
Speaker impedance
Front
4 – 16 Ω
Center
Surround
Connect
2.1-channel Connection
NOTE
Connect so that the speaker cable core wires do not protrude
from the speaker terminal. The protection circuit may be
activated if the core wires touch the rear panel or if the + and
– sides touch each other (vpage 74 “Protection Circuit”).
Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock.
n
•
•
Set Up Speakers
Here we describe how to set up speakers other than 5.1-channel speakers.
For the method of setting up 5.1-channel speakers, see “Simple Version”, “r Set Up Speakers
(Audyssey™ Auto Setup)” (vpage 6).
First install and connect the speakers to this unit.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
