ENGLISH
Remote
Control
Playback
(Advanced)
Connections
Simple
Version
Playback
(Basic)
Multi-
zone
GUISettings
Getting
Started
Troubleshooting
Other
Information
Spec. Index
Part
Names
Setting items Setting details
Cinema EQ
Soften the treble range
of movie soundtracks for
better understanding.
ON
OFF
DRC
Compress dynamic range
(difference between loud
and soft sounds).
OFF : Dynamic range compression always off.
Low / Middle / High : These set the compression level.
Auto : Automatic dynamic range compression on/off control according to
source. This can be set in the Dolby TrueHD mode.
D.COMP
Compress dynamic range
(difference between loud
and soft sounds).
OFF : Turn dynamic range compression off.
Low / Middle / High : These set the compression level.
LFE
Adjust the low-frequency
effects level (LFE).
–10dB – 0dB
For proper playback of the different sources, we recommend setting
to the values below.
Dolby Digital sources : “0dB”
DTS movie sources : “0dB”
DTS music sources : “–10dB”
•
•
•
Center Image
Assign center channel
signal to front left and right
channels for wider sound.
0.0 – 1.0 (0.3)
Only DTS NEO:6 MUSIC mode
Panorama
Assign front L/R signal also
to surround channels for
wider sound.
OFF
ON
Only Dolby PLg/PLgx MUSIC mode
Dimension
Shift sound image center
to front or rear to adjust
playback balance.
0 – 6 (3)
Only Dolby PLg/PLgx MUSIC mode
Center Width
Assign center channel
signal to front left and right
channels for wider sound.
0 – 7 (3)
Only Dolby PLg/PLgx MUSIC mode
Setting items Setting details
Front Height
Set the Dolby PLgz Height
mode to ON or OFF.
When “Speaker Assign”
is set to “5.1CH + Front
Height”, you can stop the
front height speaker output.
ON : Audio is output from the front height speaker.
OFF : Audio is not output from the front height speaker.
NOTE
“Front Height” is not displayed with the settings listed below.
When the “Speaker Assign” setting (vpage 53) is set to something
other than “5.1CH + Front Height”.
When the “Speaker Configuration” – “Front Height” setting (vpage
54) is set to “None”.
“Front Height” cannot be set if the HD Audio source being played
includes a front height channel. In this case, the Front height channel is
played back without decoding in PLgz mode, using the input signal.
•
•
•
•
AFDM
(Auto flag detect mode)
Detect the source’s
surround back channel
signal and set the
optimum surround mode
automatically.
ON
OFF
[Example] Playing Dolby Digital software (with EX flag)
When “AFDM” is set to “ON”, the surround mode is automatically set
to the DOLBY D + PLgx C mode.
To play in the DOLBY DIGITAL EX mode, set “AFDM” to “OFF” and
“Surround Back” to “MTRX ON”.
Some Dolby Digital EX sources do not include EX flags. If the playback
mode does not switch automatically even when “AFDM” is set to
“ON”, set “Surround Back” to “MTRX ON” or “PLgx CINEMA”.
NOTE
If the setting in “Speaker Configuration” – “Surround Back” (vpage 54)
is “None”, “Surround Back” is not displayed.
•
•
Audio Adjust
Remote control operation
buttons
Display the menu
Cancel the menu
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
