D-Link DWS-1008 CLI Manual 109
security {unsecured | Specifies the security level, and is applicable only when
authenticated | encrypted} applicable only when the SNMP version is usm:
• unsecured—Message exchanges are not
authenticated, nor are they encrypted.
This is the default.
• authenticated—Message exchanges are authenticated,
but are not encrypted.
• encrypted—Message exchanges are authenticated
and encrypted.
SNMPv2c with Informs
To configure a notification target for informs from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr[:udp-port-number] v2c
community-string inform [profile profile-name] [retries num] [timeout num]
target-num ID for the target. This ID is local to the switch and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
to send notifications to.
community-string Community string.
profile profile-name Notification profile this SNMP user will use to specify the notification
types to send or drop.
retries num Specifies the number of times the MSS SNMP engine will resend a
notification that has not been acknowledged by the target. You
can specify from 0 to 3 retries.
timeout num Specifies the number of seconds MSS waits for acknowledgement
of a notification. You can specify from 1 to 5 seconds.
SNMPv2c with Traps
To configure a notification target for traps from SNMPv2c, use the following command:
Syntax: set snmp notify target target-num ip-addr[:udp-port-number]
v2c community-string trap [profile profile-name]
