A SERVICE OF

logo

D-Link DWS-1008 CLI Manual 37
Port Parameter Setting
VLAN membership None.
Note: Although the command changes a port to a network port, the
command does not place the port in any VLAN. To use the port in a VLAN,
you must add the port to the VLAN.
Spanning Tree Protocol
(STP)
Based on the VLAN(s) you add the port to.
802.1X No authorization.
Port groups None.
Internet Group
Management Protocol
(IGMP) snooping
Enabled as port is added to VLANs.
Access: point and radio
parameters
Not applicable.
Maximum user sessions Not applicable.
Examples: The following command clears port 5:
DWS-1008# clear port type 5
This may disrupt currently authenticated users. Are you sure? (y/n) [n]y
success: change accepted.
See Also:
• set port type ap
• set port type wired-auth