D-Link DWS-1008 CLI Manual 393
set service-profile wep active-multicast-index
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting
multicast frames.
Syntax: set service-profile name wep active-multicast-index num
name
num
Defaults: If WEP encryption is enabled and WEP keys are defined, APs use WEP key 1 to
encrypt multicast frames, by default.
Access: Enabled.
Usage: Before using this command, you must configure values for the WEP keys you plan to
use. Use the set service-profile wep key-index command.
Examples: The following command configures service profile sp2 to use WEP key 2 for encrypting
multicast traffic:
DWS-1008# set service-profile sp2 wep active-multicast-index 2
success: change accepted.
See Also:
• set service-profile wep active-unicast-index
• set service-profile wep key-index
• show service-profile
Service profile name.
WEP key number. You can enter a value from 1 through 4.
set service-profile wep active-unicast-index
Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting unicast
frames.
Syntax: set service-profile name wep active-unicast-index num
name
num
Defaults: If WEP encryption is enabled and WEP keys are defined, APs use WEP key 1 to
encrypt unicast frames, by default.
Service profile name.
WEP key number. You can enter a value from 1 through 4.
