Solving Problems 61
Solving Problems with the Remote
Control
The projector doesn’t respond to remote control commands.
■
Make sure the tape has been removed from the battery tray as
described on page 28.
■
Make sure you are within 20 feet of the projector, and within
range of the projector’s front or back sensor (approximately 30° to
the left or right and 15° above or below).
■
The remote control battery may not be installed correctly or may
be low on power. Change the battery as described on page 48.
■
Dim the room lights and turn off any fluorescents. Make sure the
projector is not in direct sunlight. Strong lighting, especially
fluorescent lights, may affect the projector’s infrared receivers.
■
Turn off any nearby equipment that emits infrared energy, such
as a radiant room heater.
52c.book Page 61 Wednesday, October 9, 2002 2:32 PM
