Appendix A: Connecting to Additional Equipment 71
Connecting the Computer Cable
Follow these steps. You may not need to use the adapter as shown.
1. Disconnect the monitor cable from the video port on the back of
the Macintosh.
2. Connect one end of the computer cable to the projector’s
Computer/Component Video
port, as shown.
3. Connect the other end of the computer cable to the video port on
the Macintosh.
4. If it doesn’t fit and you have a DVI port, you’ll need to use a DVI
to VGA adapter. An adapter may have come with your computer.
See your Macintosh documentation for instructions.
If it doesn’t fit and you have an older Macintosh, you may have to
use a Macintosh desktop adapter, which you can buy from
EPSON (see page 7).
To use the adapter, remove its cover as shown and set its DIP
switches according to the resolution you want to use, such as
16-inch mode. See your Macintosh documentation for
instructions.
Replace the cover and connect the adapter to the free end of the
computer video cable. Then plug the cable (with the adapter) into
the video port on your Macintosh.
5. Tighten the screws on the connectors.
52c.book Page 71 Wednesday, October 9, 2002 2:32 PM
