a
• You can only enter single-byte alphanumeric characters and symbols.
• The following functions cannot be used while using Crestron
RoomView
®
.
Message Broadcasting (EasyMP Monitor plug-in)
s "Changing Settings Using a Web Browser (Web Control)"
p.186
• If you set Standby Mode to Communication On, you can control
the projector even if it is in standby mode (when the power is
off).
s Extended - Standby Mode p.122
Operating the projector from the computer
Displaying the operation window
Check the following before carrying out any operations.
• Make sure the computer and projector are connected to the network.
• Set Crestron RoomView to On in the Network menu.
s Network - Others - Crestron RoomView p.134
a
Start the Web browser on the computer.
b
Enter the IP address of the projector in the address input box of
the Web browser, and press the Enter key on the computer's
keyboard.
The operation window is displayed.
Using the operation window
A
You can perform the following operations when you click the buttons.
Button Function
Power Turns the projector power on or off.
A/V Mute Press to turn the image on or off temporarily.
s "Hiding the Image Temporarily (Shutter)" p.94
B
Switch to the image from the selected input source. To display input sources that
are not shown in Source List, click (a) or (b) to scroll up or down. The current
image signal input source is displayed in blue.
You can change the source name if necessary.
Monitoring and Controlling
194
