OpenVMS Software Installation and Upgrade Release Notes
1.7 OpenVMS Integrity server Users
ACPI Revision: 7.00
BMC Revision: 2.35
"
IPMI Revision: 1.00
SMBIOS Revision: 2.3.2a
Management Processor Revision: E.02.29
#
!
The system firmware revision is 2.13.
" The BMC firmware revision is 2.35.
# The MP firmware revision is E.02.29.
The HP Integrity rx4640 server contains Dual Hot Plug Controller (DHPC)
hardware with upgradeable firmware. To check the current version of your DHPC
firmware, use the EFI command INFO CHIPREV, as shown in the following
example. The hot-plug controller version will be displayed. A display of 0100
indicates version 1.0; a display of 0110 means version 1.1.
Shell> INFO CHIPREV
CHIP REVISION INFORMATION
Chip Logical Device Chip
Type ID ID Revision
------------------- ------- ------ --------
Memory Controller 0 122b 0023
Root Bridge 0 1229 0023
Host Bridge 0000 122e 0032
Host Bridge 0001 122e 0032
Host Bridge 0002 122e 0032
Host Bridge 0004 122e 0032
HotPlug Controller 0 0 0110
Host Bridge 0005 122e 0032
HotPlug Controller 0 0 0110
Host Bridge 0006 122e 0032
Other Bridge 0 0 0002
Other Bridge 0 0 0008
Baseboard MC 0 0 0235
For instructions on how to access and use EFI, see the HP OpenVMS Version 8.4
Upgrade and Installation Manual. For more information, refer to the hardware
documentation that is provided with your server.
For instructions on upgrading your firmware for your entry-class Integrity
servers, see the HP OpenVMS Version 8.4 Upgrade and Installation Manual.To
upgrade firmware for the rx7620, rx8620, or Superdome, contact HP Customer
Support.
1.7.5 Booting from the Installation DVD
V8.2
On Integrity servers with the minimum amount of supported memory (512 MB),
the following message appears when booting from the installation DVD:
********* XFC-W-MemmgtInit Misconfigure Detected ********
XFC-E-MemMisconfigure MPW_HILIM + FREEGOAL > Physical Memory and no reserved memory for XFC
XFC-I-RECONFIG Setting MPW$GL_HILIM to no more than 25% of physical memory XFC-I-RECONFIG
Setting FREEGOAL to no more than 10% of physical memory
********* XFC-W-MemMisconfigure AUTOGEN should be run to correct configuration ********
********* XFC-I-MemmgtInit Bootstrap continuing ********
OpenVMS Software Installation and Upgrade Release Notes 1–7
